Time control switch intermittent infinite loop countdown switch controller timing RFID relay module 12V 5V

1: Size: 65mm*36mm*18mm

2: Output capacity: DC 5~30V 5A AC 220V5A

3: Static current: 20mA Working current: 50mA

4: Working voltage: DC12V (fluctuations between 10V and 16V will not be affected) and 5V is optional, please leave a message if you need 5V.

5: Service life: more than 100,000 times Working temperature: -40~85'C

6: The output adopts optocoupler isolation to enhance the anti-interference ability and power consumption to ensure stability. The industrial-grade circuit board is similar to PLC. The set parameters can be remembered forever after power off.

The method of setting the time is also very simple:

After the power is turned on, the countdown time starts and the relay works.

K1 is divided into six cycles, the first three times are the time for setting on, and the last three times are the time for setting off. Press K1, the hundreds digit digital tube starts to flash, press K2 at this time, the hundreds digit changes; Blinking, press K2 at this time, the ones digit changes; and so on until the digital tube is no longer flashing; press K2 at this time, the decimal point shifts, the decimal point represents 0 to 999 minutes in the ones digit, and 0 to 99.9 in the tens digit Seconds without a decimal point means 0 to 999 seconds; after selection, the time setting is now complete. Long press K2 to turn on or off the digital tube to reduce power consumption.